Lead-free solder bars

Zhongya(Tianjin) uses the advanced technology of refining and high anti-oxidation, to develop the lead-free solder bar for wave soldering and dip soldering, especially for the automatic assembly line in mass production. This product meets the requirement of the EU RoHS environmental directive.

Advantages

  1. With high anti-oxidation technology, the rate of tin slag is low .We can save the material cost about 6%
  2. Excellent fluidity and wettability, the solder joint is bright and full.
  3. In order to meet the different soldering requirements and adapt to a variety of soldering operation, we provide a wide range of alloy compositions and various types of solder bars for the user to choose.

4-1 Anti-oxidized Lead-free Wave Soldering Bar

Based on the low slag type solder composition and the advanced casting process, The limitation of molten temperature rises to about 400℃ by the addition of special antionxidant. The liquid solder suerface is very bright and like a mirrror. WIth this solder, bright and beautiful solder joints can be obtained, meanwhile the slag is much lower than the ordinary products, which can reduce the rate of failure in solder Joints and production costs.

4-2 High purity lead-free wave soldering bar

With the high-purity (99.99%) Sn as raw material and strict control of impurity content below 100ppm, the products meet the requirements of RoHS directive.

4-3 Extinction and Anti-oxidated Type Wave Soldering Bar

By extinction technology according to the user's requirements , the solder joints is matt after soldering, We can reduce the reflected light by the solder surface in the testing. It can protect the eyes of inspectors and increase the speed of test to ensure test quality.

4-4 Low-melting-point(79℃-138℃)Solder Bar

Series Melting point Product Status
  Solidus Liquidus Wire Bar
DHL-79※ 79
DHL-130※ 130
DHL-138※ 138 φ1.0-3.0mm
Note:※ means lead-free solder, △ represents the available products, and stands for unsupplied products.

4-5 High Purity Series Soldering Bar

In wave soldering, the composition of solder should be periodically measured in boiler, because the tin content will get low ,meanwhile the content of copper and lead increase. In order to reduce product costs, right amount of high purity series soldering bar or antioxidized alloys should be added when the content of copper or lead is close to the standard.

津ICP備05011517號-1 Copyright © 2010 Cooper ZhongyaSolder,Inc All Rights
海南高频彩票 2021波叔一波中特彩图 黑龙江11选5开奖结果走势 河南快赢481 新浪篮球比分直播 92千炮捕鱼 辽宁25选5开奖结果 江苏7位数如何中奖 十平码专区十明日大富 福彩3d跨度走势图500期 极速快乐十分官网 天天捕鱼赢话费电玩版 盛源彩票官方网站-Welcome 3d福彩开奖 极速快3玩法技巧 陕西11选5走势图一号码遗漏一走势图 幸运赛车走势图及奖金